Aspect Ratio: 3:2, 4:3, 16:9 and Which to Use
Which ratio each camera produces, which one prints without cropping, why a 3:2 loses 18 mm on A4 and when to crop to 16:9 in editing.
Shoot in your sensor's native ratio (3:2 on almost every DSLR and mirrorless, 4:3 on Micro Four Thirds and on the phone) and decide the crop when you export. A 3:2 frame measures 1.50 to 1. An A4 sheet measures 297 ÷ 210 = 1.4143 to 1. Those two numbers don't fit, and that is where the print that comes back from the lab with the top of the head cut off comes from.
Aspect ratio is the long side divided by the short side, nothing more.
What ratio does each camera format give?
Five ratios cover almost everything you will see in a camera menu or a lab catalog. The last column says where you lose pixels if you start from that ratio.
Ratio: 3:2 (1.50); What produces it: Full frame and APS-C DSLRs and mirrorless, 35 mm film; Prints without cropping on: 4 × 6 in (10 × 15 cm), 20 × 30, 30 × 45 cm; Where it gets cropped: A4, 13 × 18, letter, square
Ratio: 4:3 (1.33); What produces it: Micro Four Thirds, phone camera by default, 44 × 33 mm medium format; Prints without cropping on: 15 × 20, 18 × 24, 30 × 40 cm; Where it gets cropped: 10 × 15 and anything that is 1.50
Ratio: 16:9 (1.78); What produces it: HD and UHD video, the camera's 16:9 mode, screens; Prints without cropping on: No catalog photo paper; Where it gets cropped: On all paper, and in the vertical format of social networks
Ratio: 1:1 (1.00); What produces it: Square mode, 6 × 6 film, a Polaroid's image area; Prints without cropping on: Square paper, 20 × 20 cm; Where it gets cropped: On any rectangular paper
Ratio: 5:4 (1.25); What produces it: 4 × 5 inch large format, 5:4 mode; Prints without cropping on: 20 × 25 cm (8 × 10 in), 40 × 50 cm; Where it gets cropped: 10 × 15, 20 × 30
Sensors called 3:2 are not exact. A 36 × 24 mm full frame does give exactly 1.5000, but a 23.5 × 15.6 mm APS-C gives 1.5064 and a 22.3 × 14.9 mm one gives 1.4966: deviations below 0.5%, invisible on paper. The dimensions of each format are in camera sensor sizes.
Micro Four Thirds is named after its ratio, and shares its crop with 44 × 33 mm medium format (which gives exactly 1.3333) despite the difference in surface area.
Why do your printed copies come out cropped?
Because the paper was manufactured with a different ratio than your sensor. The math is two lines and works for any paper.
13 × 18 cm. The paper is 18 ÷ 13 = 1.3846. Rest your 3:2 on the short side: 13 cm × 1.5 = 19.5 cm of long side, and the paper only has 18. That leaves 1.5 cm, or 15 mm extra, which centered is 7.5 mm at each end of the long side. As a percentage, 1.5 ÷ 19.5 = 7.7% of the long dimension.
A4, 210 × 297 mm. The paper is 297 ÷ 210 = 1.4143 (rounded to four decimals; the exact value is irrational, because the A series is defined by the square root of two). Rest the 3:2 on the 210 mm short side and you need 315 mm of length. There are 297. 18 mm go away, nine per end, 5.7% of the long side.
The alternative is not to crop and accept a white border: if you rest the 3:2 on the 297 mm long side, the short side ends up at 297 ÷ 1.5 = 198 mm on a 210 mm sheet, which is 12 mm of empty paper, 6 mm on top and 6 on the bottom. You choose: 18 mm of photo or 12 mm of white.
Where those millimeters fall depends on orientation, and this is what ruins portraits. In landscape orientation the crop takes the left and right ends. In portrait orientation it takes top and bottom, and the lab crops centered because it is the only thing it can do without seeing the face: nine millimeters of the top of the head and nine of the chin. If you leave 3-5 mm of breathing room on each side when framing, the crop eats the room and not the subject. The percentages for all commercial formats are tabulated in standard photo sizes for printing, and the print size calculator tells you up to what size your specific file reaches.
What is the 16:9 aspect ratio for?
16 ÷ 9 = 1.7778, the ratio of HD and UHD video: 1920 × 1080 and 3840 × 2160 give exactly that figure.
It is useful for delivering stills that will be assembled alongside video, for a web header or a screen (almost always 16:9) and as a composition decision: a moderate panoramic forces you to resolve the framing horizontally and punishes empty sky.
It is not useful for catalog printing. No common photo paper is 1.78, so a printed 16:9 means custom cutting, mounting on a larger sheet with uneven margins, or a second crop that undoes the first.
Starting from a sample 6000 × 4000 px file in 3:2, 16:9 keeps the 6000 width and lowers the height to 6000 × 9 ÷ 16 = 3375 px. 625 rows go away, 15.6% of the height, and the file goes from 24 to 20.25 megapixels. From a 4000 × 3000 px 4:3 the penalty is greater: the height falls to 2250 px, 25% less. At 300 ppi, that 6000 × 3375 prints at 50.8 × 28.6 cm: pixels divided by density, the calculation broken down in resolution and printing.
Cropping to 16:9 in the camera or in editing
Crop in editing, unless you need to compose in the final ratio through the viewfinder.
A crop made in camera on the JPEG writes 6000 × 3375 px to disk and that's it: the 625 rows never made it into the file. If three months later the client asks for a 20 × 30 cm print (which is 3:2) there is nowhere to get them from. Nor can you slide the strip upward to save a crooked horizon: there is no margin left, what you see is all there is.
The same crop done in the editor delivers exactly the same 6000 × 3375 px output, and the original, 4000 px tall, is still on the disk.
Check it on your own gear: in RAW, quite a few cameras save the full frame and only mark the ratio as a tag that the editor can undo. The behavior changes between manufacturers and between models, so shoot one frame in 16:9 mode, open it in your editor and try to go back to 3:2. If you get it back, the 16:9 mode is only helping you compose; if not, it is deleting pixels.
What ratio should I use for each destination?
Destination: 10 × 15, 20 × 30 or 30 × 45 cm print; Output ratio: 3:2; What to do on export: Nothing: the file already fits
Destination: A4 or 13 × 18 cm print; Output ratio: 1.41 / 1.38; What to do on export: Crop yourself before sending and you decide what goes
Destination: Portrait for the wall, 20 × 25 or 40 × 50 cm; Output ratio: 5:4; What to do on export: Crop 16.7% of the long side from a 3:2
Destination: Video, web header, screen; Output ratio: 16:9; What to do on export: Crop in the editor, never in camera
Destination: ID photo; Output ratio: Whatever the procedure sets; What to do on export: 3.5 × 4.5 cm is 1.2857, and 2 × 2 in is 1:1
Destination: Social networks; Output ratio: Whatever the platforms publish; What to do on export: It changes without notice: check the current specification before exporting
No camera ratio matches the 1.2857 of an ID photo, so a passport photo is always a crop made on purpose, and the measurement is set by the authority that issues the document, not by the lab or this page. The most requested sizes and the sheet layout to print them are in the tool for photo sizes for documents; the official requirement, in the call for the procedure.
Frequently asked questions
What is the best aspect ratio for photography?
Your camera's native one when shooting (3:2 on most DSLRs and mirrorless, 4:3 on Micro Four Thirds and on phones) because it is the only one that uses all the sensor's pixels. The output ratio is decided afterward, according to the destination: 3:2 for 10 × 15 and 20 × 30 prints, 5:4 for the wall, 16:9 for screens.
Do I lose quality if I shoot in 16:9?
In JPEG, yes: real pixels are lost. A 6000 × 4000 px file ends up at 6000 × 3375, 15.6% less height and 3.75 megapixels fewer. A crop made later in the editor gives the same framing without destroying the original.
Why does my photo leave white borders when printing on A4?
Because A4 is 1.4143 to 1 and your file is 1.50 to 1. If the lab fits to the long side, the short side stays at 198 mm on 210 and 6 mm of white appear on top and bottom; if it fits to the short side, there is no white but 18 mm of photo go away.
What aspect ratio does a phone photo have?
The main camera of most phones delivers 4:3 by default, which is the sensor's ratio. The "16:9" or "full screen" modes on the same phone are crops of that 4:3, not a larger capture, which is why the resulting file weighs and measures less.
Is 1920 × 1080 the same as 16:9?
That resolution is 16:9, because 1920 ÷ 1080 = 1.7778. But 16:9 is a ratio and says nothing about the number of pixels: 1280 × 720 and 3840 × 2160 are also 16:9, and the second holds nine times more information.
What to check before exporting
Divide the paper's long side by its short side and compare it with 1.50. If they don't match, the crop exists and someone is going to decide it; better that it be you.
Crop to the ratio, never to the size in centimeters, and leave breathing room around the subject.
Always keep the full file even if you export in 16:9: the next job almost never asks for the same shape as the last.
The 44 Enfogram cards come with the ratios, crop percentages and paper sizes printed, in A4 and A5, so you can solve the framing in front of the scene and not in front of the counter.