Light metering
Light metering is how the camera analyzes the brightness of a scene to calculate a “correct” exposure, using matrix, center-weighted or spot modes.
Also known as: metering, exposure metering, metering modes
Light metering is the system the camera uses to analyze the brightness of the scene and calculate a “correct” exposure. The three main modes are: matrix (evaluates the whole scene in zones and averages, the most versatile default mode), center-weighted (prioritizes the center of the frame) and spot (measures only a small point, ideal for subjects against very contrasty backgrounds).
Choosing the mode is choosing which part of the frame gets to decide the exposure.
No metering mode “knows” what's important in the scene: that's why, in difficult situations (backlighting, snow, very dark or very bright backgrounds), the photographer steps in with exposure compensation or switches modes.
Which mode should I use in each scene?
Scene: Landscape with evenly spread light; Mode: Matrix; Compensation: 0 EV; Why: The scene averages close to middle gray
Scene: Backlit portrait; Mode: Spot on the face; Compensation: +1 EV on fair skin; Why: The bright background stops counting
Scene: Snow or beach in full sun; Mode: Matrix; Compensation: +1.5 to +2 EV; Why: White turns into gray
Scene: Stage with a spotlight; Mode: Spot on the face; Compensation: 0 EV; Why: The black background would fool matrix
Scene: Bird against a white sky; Mode: Center-weighted; Compensation: +0.7 EV; Why: The sky weighs in, but doesn't fully take over
Scene: Interior with a window in the background; Mode: Spot on the lit wall; Compensation: 0 EV; Why: You decide which area is preserved
Scene: Documentary shoot that changes every second; Mode: Matrix; Compensation: 0 EV, correct by histogram; Why: There's no time to meter by zones
On many cameras the spot metering point follows the active autofocus point, not the center of the frame. Check it in the menu before you rely on it: if it's locked to the center, metering and then recomposing changes the reading.
What exactly do I meter on with spot metering?
On something whose tone you know, and then you place that tone where it should be. The meter always returns the setting that would leave what it measured at middle gray, so the question isn't “where do I meter?” but “how many stops above or below gray should this end up?”.
Lit fair skin: falls roughly 1 stop above middle gray, so you meter on the cheek and apply +1 EV.
Lit dark skin: sits around middle gray; meter and don't compensate.
Green grass, dry asphalt, brick: are very close to middle gray, and serve as a free reference in any scene.
Sunlit snow: about 2 stops above; you meter on it and apply +2 EV.
A handheld light meter in incident mode solves all this in a different way: it measures the light falling on the subject instead of the light it reflects, so the color of the dress and the background stop mattering. That is what makes it irreplaceable in the studio.
Common mistakes
Changing modes instead of compensating. Switching to spot in a scene that changes every few seconds produces erratic exposures, because each photo meters on a different point. In documentary work, stay in matrix and correct with the compensation dial.
Forgetting the compensation you set. The +2 EV from the snow is still there two hours later, inside the mountain hut. Reset it to zero every time you change scenes.
Metering on the sky in a backlit landscape. The result is correct for the sky and leaves the terrain three stops under. Meter on what you want to have detail, and check on the histogram what has gone off the ends.
To choose the mode with judgment in each genre, see the guide to strategic light metering and the article common exposure mistakes and how to avoid them.