Skip to content
← Glossary

Bounce flash

Bounce flash means aiming the flash head at a ceiling or light wall instead of the subject, so the surface returns the light as a huge, soft source.

Also known as: bounced flash, flash bounce

Bounce flash consists of aiming the flash head at the ceiling or a light-colored wall instead of at the subject, so that the surface returns the light as a huge source. A white ceiling at 3 m lights like a diffuser a couple of meters on a side, and that is the whole difference between the hard shadow of direct flash and a soft transition.

Comparison of two light paths seen from the side: with direct flash a narrow cone goes from the camera to the subject and casts a hard shadow on the wall; with bounce flash the cone goes up to the ceiling, becomes a wide patch of light and comes down on the subject in a broad cone

Bouncing doesn't change the flash's power: it changes the size of the source lighting the subject.

It requires a flash with a swiveling head —the camera's built-in one can't bounce— and a light, neutral surface. A beige wall returns beige light, and that cast shows up right on the skin.

How much power do I lose when bouncing?

Quite a lot. The light travels twice the distance and the surface absorbs some, so a white ceiling at 3 m costs on the order of two to three stops compared with direct flash. The exact value depends on the height, the color of the ceiling and the flash's guide number, which is why there is no single figure.

With TTL metering the camera compensates for that loss on its own until the flash reaches full power. The symptom of having reached the limit is that the photo comes out underexposed even though the TTL reads correct: from there the solution is to raise the ISO, not to keep pushing the flash.

A base that works in an event interior: ISO 1600, f/4, 1/60 s and TTL with flash compensation between 0 and +1 EV. The ambient light provides the background and the bounce makes the subject. If the background comes out black, lower the shutter speed before raising the flash.

What angle do I give the head?

  • Bounce surface: White ceiling at 2.5-3 m; Head angle: 60-75° up and slightly back; Result: Soft overhead light; When to use it: Interiors in general

  • Bounce surface: White ceiling with a bounce card; Head angle: 75° with the card out; Result: Overhead with catchlights in the eyes; When to use it: Event portraits

  • Bounce surface: White side wall at 1-2 m; Head angle: 90° toward the wall; Result: Window-like side light; When to use it: Portraits with volume

  • Bounce surface: Wall behind the photographer; Head angle: 180°, backward; Result: Very soft, flat frontal light; When to use it: Groups, no time to set up

  • Bounce surface: Ceiling over 4 m or colored; Head angle: —; Result: Bounce not viable; When to use it: Diffuser, or direct with a modifier

Pointing straight up, at 90°, is the angle that leaves the most dark circles: the light falls vertically and the eye sockets fall into shadow. Tilting the head back moves the apparent source above and slightly behind you, and that light reaches the face with more frontal angle.

Common mistakes

Bouncing off a wooden or colored ceiling. The warm or green cast lands on the skin, and correcting it in processing drags the rest of the image along with it.

Forgetting the sync speed. Above the shutter limit (1/200 or 1/250 s on most cameras, except in high-speed mode) a black band appears in the frame.

Bouncing outdoors. With no ceiling or walls, a flash pointed up lights nothing. Outside, direct flash with a diffuser works as fill light.

Shooting a burst with the flash at its limit. Recycle time leaves shots at half power that look like an exposure error without being one.

What to check when you walk into the room

Look at the ceiling before taking out the camera: height, color and whether there are beams. With that you already know whether you will bounce, in which direction and with what starting ISO. For the complete workflow with flash, see the guide to flash lighting and the article bounce flash: ceiling and walls as a softbox.

  • Blog
    Night Portraits with Flash and Ambient Light

    Night portrait with flash: balance ambient light and flash with exact settings, rear-curtain sync, gels and a well-used guide number.

  • Glossary
    Catchlight

    A catchlight is the specular reflection of the light source in a subject's eyes in a portrait, giving the gaze life and depth.

  • Guide
    Studio Lighting Concepts

    Studio lighting is architecture with light: each source has a function and its quality depends on the relative size of the source.

  • Blog
    Boudoir Photography: Light, Poses and Confidence

    How to approach boudoir professionally: the pre-shoot conversation, written consent, window light and measured settings for full frame.

  • Glossary
    Blue hour

    Blue hour is the brief window of light just before sunrise or after sunset, when the sun is below the horizon but its light still tints the sky deep blue.

  • Guide
    Low-Light Photography

    Having little light is not a problem, it's a creative opportunity. The key is balancing ISO, aperture and shutter speed to match your creative vision.

  • Guide
    Studio Lighting Concepts

    Studio lighting is architecture with light: each source has a function and its quality depends on the relative size of the source.

  • Guide
    Low-Light Photography

    Having little light is not a problem, it's a creative opportunity. The key is balancing ISO, aperture and shutter speed to match your creative vision.

  • Guide
    Natural Light Basics for Photographers

    Natural light constantly changes in quality, direction and intensity. There is no "bad light," only light unsuited to what you are trying to communicate.

  • Guide
    Flash Lighting Without Auto Mode

    Flash doesn't just add light: it sculpts the exact mood you need by understanding the relationship between power, aperture, ISO and ambient light.

  • Guide
    Creative White Balance

    White balance is a storytelling tool: adjusting it manually lets you create atmospheres that support your visual message.

  • Guide
    Strategic Light Metering

    Metering systems do not know what is important in your scene: understanding each mode gives you creative control over exposure.